Front Seat installation:

  1. Remove the headrests (as applicable).
  2. Line the cover’s back section’s seams up with your seat’s contours and wrap it around the seat back. Gently pull it tight while keeping the seams lined up.
    Front Seat
  3. Tuck the extra seat cover material through the space between your seat back and cushion and secure it with the included straps, or Velcro. Make these attachments as tight as possible.
  4. Slip the bottom cover over the lower cushion, keeping the cover’s seams lined up with those on your seat.
  5. Tie the bottom cover in place using the included tie-down straps buckle or bungee cord. Tighten the straps for the best fit.
  6. Tuck the extra material on the side of the seats into the plastic housing where your adjusting controls are.
  7. Slip the headrest covers on and reinstall the head rests.

Rear Seat installation:

  1. If you have headrests, remove them.
  2. Unlatch the back seats or use the handle to collapse the back rest just enough to be able to slip the seat covers over the top.
  3. Tuck the extra seat cover material through the space between your seat back and cushion and secure it with the included straps, or Velcro. Make these attachments as tight as possible.
  4. The bottom part of the seats usually pop out by pushing the bottom seat between the backrest and the cushion.
  5. Slip the covers over the edge of the bottom seat and gently pull them back.
  6. Flip the bottom seat over and tighten the buckles until the seat cover is snug over your seat.
    Rear Seat Bottom
  7. If you have a bungee cord, route this around the edge of the seat towards the back and attach both ends with the provided hooks.